| Energol GR-XP |
Energol GR-XP is a range of lead-free extreme pressure gear oils.
|
| Application |
Application Energol GR-XP is a range of oils intended for use in heavily loaded spur, bevel and helical gears, either splash or forced feed lubricated.
|
| Main Performance Features |
- • High thermal stability allowing intermittent bulk operating temperatures up to 1200C.
- • Attention-free operation between standard overhauls even at high temperatures and in adverse conditions.
- • Maximum protection against corrosion and wear.
- • Extreme pressure properties exceeding FZG 12th stage.
|
| Approvals |
Approved by, or meets the specification requirements of, major gear manufacturers.
|
| Care and Handling |
Bulk oil temperatures should not exceed 120?C.In any system that incorporates electric heaters for effecting rapid warm-up, it is important to avoid high rates of heat input. Heat fluxes in excess of 15kW/m? are likely to cause separation of additives, and this would affect the oil's lubrication performance.
|
| Packaging and Storage |
Supplied in drums of approximately 210 liters. Where outdoor storage is unavoidable, drums should be covered. The drums should be stored in such a way as to ensure they are not damaged and grade markings not obliterated; position them horizontally so as to prevent water collecting on drum ends. Ensure drums are tightly re-sealed after use.
|
| Typical Characteristics |
| | Test Method | Units | 68 | 100 | 150 | 220 | 320 | 460 | 680 |
| Kinematics’ Viscosity | ASTM D445 | mm2 s-1 | 65 | 96 | 140 | 210 | 305 | 450 | 635 |
| Density | ASTM D1298 | kg/m3 | 890 | 890 | 900 | 900 | 900 | 910 | 920 |
| Flash Point (PMC) | ASTM D93 | 0C | 193 | 193 | 196 | 196 | 199 | 199 | 199 |
| Rusting FZG | ASTM DD665B | -----------------------------------------Nil--------------------------------------- |
| Gear Test (Load Stage) | A/16.6/110 0C | --------------------------------------Above 12--------------------------------- |
| Pour point | ASTM D97 | 0C | -24 | -24 | -24 | -21 | -15 | -9 | -9 |
The above figures are typical of those obtained with normal production tolerances, and do not constitute a specification. Note 1 mm2 s-1 = 1 cSt.
|
| Health, Safety and Environment |
Health, safety and environmental information is provided for this product in the Material Safety Data Sheet. This gives details of potential hazards, precautions and First Aid measures, together with environmental effects and disposal of used products. The British Petroleum Company plc or its subsidiaries will not accept liability if the product is used other than in the manner or with the precautions or for the purpose/s specified. Before the product is used other than as directed, advice should be obtained from the local BP office.
|
|
|
Copyright BP Oil International Ltd.
