| Energol RC |
Energol RC is inhibited oil for use in reciprocating air-compressors.
|
| Application |
Energol RC is recommended for the lubrication of reciprocating-type air-compressors. It is particularly suitable for compressors with high air delivery temperatures - up to 220?C - where oils of inferior quality would quickly deteriorate and leave carbonaceous deposits within the compressor and discharge system. Energol RC can also be used for drip-feed vane-type compressors that require oils with good oxidation stability and incorporating rust inhibitors. In addition Energol RC can be used in circulatory lubrication systems of plain and rolling bearings that operate at high temperatures and in turbochargers.
|
| Main Performance Features |
- Low deposit-forming tendency, hence longer intervals between overhauls.
- The possibility of extended oil-change intervals, hence a marked reduction in maintenance costs.
|
| Approvals |
Energol RC 68 is approved by ABB Turbo Systems for VTR turbochargers for 3,000 hour oil-drain intervals. Energol RC 150 is approved for breathing air applications with Bauer air purification systems. Energol RC fully meets the standards set by leading compressor manufacturers world-wide and meets the requirements of DIN 51 506, Category VD-L, DIN 51 352 Part 2 (Pneurop Oxidation Test).
|
| Care and Handling |
To be used in accordance with equipment manufacturers' recommendations, particularly with regard to oil and filter change intervals where appropriate.
|
| Packaging and Storage |
Supplied in drums of approximately 210 liters and small packs of approximately 20 liters. Note that pack size may vary according to country of supply. Where outdoor storage is unavoidable, drums should be covered. The drums should be stored in such a way as to ensure that they are not damaged and grade markings not obliterated; position them horizontally to prevent water collecting on drum ends. Ensure packs are tightly re-sealed after use.
|
| Typical Characteristics |
| | Test Method | Units | RC68 | RC100 | RC 150 |
| Kinematics Viscosity 1000C | ASTM D445 | mm2 s-1 | 68 | 98 | 145 |
| Density 150C | ASTM D1298 | kg/m3 | 880 | 890 | 900 |
| Flash Point (PMC) | ASTM D93 | 0C | 209 | 224 | 245 |
| Viscosity Index | ASTM D2270 | | 104 | 98 | 92 |
| Pour point | ASTM D97 | 0C | -30 | -30 | -12 |
The above figures are typical of those obtained with normal production tolerances, and do not constitute a specification. Note 1 mm2 s-1 = 1 cSt.
|
| Health, Safety and Environment |
Health, safety and environmental information is provided for this product in the Material Safety Data Sheet. This gives details of potential hazards, precautions and First Aid measures, together with environmental effects and disposal of used products. The British Petroleum Company plc or its subsidiaries will not accept liability if the product is used other than in the manner or with the precautions or for the purpose/s specified. Before the product is used other than as directed, advice should be obtained from the local BP office.
|
|
|
Copyright BP Oil International Ltd.
